Carrier GRAVINER Mk 6 - 3.3 Engine Screen User

Nov-21 Page 65 of 132 59812-K001 Rev 10
3.2.2 Engineer Level
A 6-digit pin is required to access the Engineer Level.
To enter the Engineer Level, press the Main Menu key on the Control Panel.
Figure 75 Main Menu
Using the numeric keys enter password 012345 to display the Engineers Main Menu
Figure 76 Main Menu Engineer Level
3.2.3 Service Level
A 6-digit pin is required to access the Service Level.
Service level access is reserved for Carrier approved Service Engineers.
3.3 ENGINE SCREEN USER
Information on a single engine can be accessed by pressing the Engine Display | Hold key.
The engine screen displays a bar graph for each detector, up to 14 detectors.
Figure 77 Engine Screen User
The detector number is shown below the bar graph.
The height of each bar indicates the oil mist level being measured by the detectors at that moment in
time. The scale on the left-hand side indicates the oil mist level in mg/l. The indicated level will change
real time as the oil mist level in the cylinder changes.
The last, right most, bar shows the average oil mist level calculated for the engine.
Alarm levels are indicated by the short lines to the right of each bar graph. The line indicating the Average
Alarm level remains fixed at the set level while the Deviation Alarm levels will fluctuate maintaining a
set level above the current engine average level.