3.5.2 Fault Relay
Allows the Fault Relay to be tested.
1. Select 2. Fault Relay
Figure 84 Fault Relay Test
2. Select Enable or Disable to change the relay state and ensure that the correct engine
response is initiated by the AMS.
3.5.3 System Test
This is a legacy option and no longer performs a function. If selected the screen returns to the Test
Menu.
3.5.4 LED/LCD Test
The test allows a visual inspection to be made of the LCD and LED operation on the Control Panel.
Select 4.LED/LCD Test, the panel will;
r operation.
Each line of the display will be made dark allowing the LCD pixels to be visually checked.
The text shown in Figure 85 will be displayed, the Version being the current software in the
Control Panel.
The Control Panel buzzer will sound at the end of the test allowing an audible check of the buzzer.
After completion of the test sequence the screen returns to the test menu.
Figure 85 LED/LCD Test
To Next Page
Loading...
