DISTRIBUTION SYSTEMS - SECONDARY HYDR AULIC POWER SYSTEM
Oil cooler - Remove (A.12.A.32 - F.10.A.10)
435, 445, 445CT
1. Remove the cap from the hydraulic reservoir and
install the CAS1871 on the reservoir.
2. Connect the CAS10192 vacuum pump to the
adapter.
3. Reservoir - Apply vacuum (A.10.A.22 - F.35.A.50)
If th e machine is equipped with a second auxiliary oil
cooler do th
e following steps. Loosen and remove
the hydraulic hose fittings from the secon d auxiliary
oil cooler and install plugs and caps on the fittin gs.
bd04c087 1
4. Loosen and remove the bolts, nuts, and washers
which fas
ten the se co n d auxiliary oil cooler to the
radiator. Remov e the second auxiliary oil cooler
from the radiato r.
bd04c0
86
2
1 04/05/2005
A.12.A / 15
To Next Page
Loading...
