Case 445 - Oil Cooler - Remove (A.10.A.32 - F.10.A.10)

DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
Oil cooler - Remove (A.10.A.32 - F.10.A.10)
435, 445, 445CT
1. Lift the hood.
2. Open t he rea r access doo r on the machin e.
3. Slowly loosen the radiator cap.
BD04C002x
1
4. Install a hose on the drain valve and drain
the radiator into a clean container that holds
approxima
tely 19 litres (5 gallons).
NOTE: During installa tio n , fi ll the radiator and coolant
reservoi
r completely. ENGINE COOLANT SYSTEM -
Capacity (B.50.A - D.40.A.20) Start and run the engine
until the coolant is at operating temperature. Stop the
engine an
d check for leakage. When the coolant is cold,
check the coolant reservoir level. Add coola nt as required.
BD04C00
3
2
5. Loosen t
he hose clamps on the upper and lower
radiator hoses. Remove the upper and lower
radiator hoses from the radiator.
bdo4c007 3
1 04/05/2005
A.10.A / 59