DISTRIBUTION SYSTEMS - SECONDARY HYDR AULIC POWER SYSTEM
Oil cooler - Install (A.12.A.32 - F.10.A.15)
435, 445, 445CT
1. Install the se cond auxiliary oil cooler into the
mounting location.
2. Install and ti
ghten the mounting bolts in the oil
cooler mounting bracket.
bd04c086 1
3. Start the v
acuum pump. Reservoir - Apply
vacuum (A.10.A.22 - F.35.A.50)
4. Remove the caps from the fittings and plug s from
the hos es.
5. Install the hydraulic lines onto the oil cooler and
tighten the fittings.
bd04c087 2
6. Stop the vacuum pump.
7. Remove the vacuum pump from the reservoir.
8. Start a nd run the engine at low idle for 2 to 5 minutes
and c heck for any leaks.
9. Check the oil level in the hydraulic reservoir and
add oil as required. Reservoir - Filling (A.10.A.22 -
F.
60.A.10)
1 04/05/2005
A.12.A / 16
To Next Page
Loading...
