DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
Oil cooler - Install (A.10.A.32 - F.10.A.15)
435, 445, 445CT
1. Oil cooler - Remove (A.10.A.32 - F.10.A.10)
Installation of the oil cooler is the reverse procedure
of O il Cooler Remove.
2. After installation of the oil cooler do the following
procedure.
3. Start a nd run the engine at low idle for 2 to 5 minutes
and check fo
r any leaks.
4. Stop the engine.
5. Check the oil level in the hydraulic reservoir and
add oil as required. Reservoir - Filling (A.10.A.22 -
F.60.A .10)
1 04/05/2005
A.10.A / 62
To Next Page
Loading...
