DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
Reservoir - Filling (A.10.A.22 - F.60.A.10)
435, 445, 445CT
1. Lower the loader lift arms to the ground and shut
off the engine.
2. Clean the reservoir filler cap and the area around
the filler cap
with cleaning solvent.
3. Turn the filler cap 1/2 turn to relieve air pressure
from the reservoir. Do not remove the filler cap from
the reservoir until the pressure is relieved.
4. Remove the filler cap from the reservoir.
5. Add the correct oil CASE AKCELA AUTO
SUPREME SAE 10W-30 to the reservoir until the
proper oil level in the reservoir is established. Fill
the reservoir until the oil level is at the mid point of
thesitegauge.
6. Start a
nd run the engine and operate the hydraulics.
Lower the loader lift arms to the ground. Stop the
engine and check the oil level in the reservoir. Add
oil as r
equired.
1 04/05/2005
A.10.A / 54
To Next Page
Loading...
