213
USING THE CAMERA WITH A COMPUTER
3. Press the camera’s [ON/OFF] button to turn it
on and then press [MENU].
• Do not place the camera on the USB cradle yet.
4. On the “Set Up” tab, select “USB” and then
press [X].
5. Use [S] and [T] to select “Mass Storage” and
then press [SET].
6. Press the camera’s [ON/OFF] button to turn it
off and then place the camera on the USB
cradle.
• Do not place the camera onto the USB cradle while it is
turned on.
• If you plan to transfer images from the camera’s built-in
memory to your computer, make sure there is no memory
card loaded in the camera.
7. Press the USB
cradle’s [USB] button.
USB Lamp
[USB]
To Next Page
Loading...
Need help?
General
