1-11
k Using the Clipboard for Copy and Paste
You can copy (or cut) a function, command, or other input to the clipboard, and then paste the
clipboard contents at another location.
Note
In the Math input/output mode, the copy (or cut) range you can specify is limited by the range
of movement of the cursor. In the case of parentheses, you can select any range within a
parenthetical expression or you can select the entire parenthetical expression.
u To specify the copy range
1. Move the cursor ( ) to the beginning or end of the range of text you want to copy and then
press !i(CLIP).
• This will cause
to appear in the status bar.
2. Use the cursor keys to move the cursor and highlight the range of text you want to copy.
3. Press 1(COPY) to copy the highlighted text to the clipboard, and exit the copy range
specification mode.
The selected characters are not
changed when you copy them.
To cancel text highlighting without performing a copy operation, press J.
u To cut the text
1. Move the cursor ( ) to the beginning or end of the range of text you want to cut and then
press !i(CLIP).
• This will cause
to appear in the status bar.
2. Use the cursor keys to move the cursor and highlight the range of text you want to cut.
3. Press 2(CUT) to cut the highlighted text to the clipboard.
Cutting causes the original
characters to be deleted.
To Next Page
Loading...
