Casio FX-CG10 - Performing Data Communication between Two Calculators

13-10
2. Performing Data Communication between Two
Calculators
k Connecting Two Calculators
The following procedure describes how to connect two calculators with the connecting cable
that comes equipped as a standard accessory.
u To connect two calculators
1. Check to make sure that the power of both calculators is off.
2. Connect the two calculators using the cable.
3. Perform the following steps on both calculators to specify 3PIN as the cable type.
(1) From the Main Menu, enter the Link mode.
(2) Press 4(CABLE). This displays the cable type selection screen.
(3) Press 2(3PIN).
Cable
• Models that are supported for this configuration are shown below.
fx-CG10, fx-CG20, fx-9860G
II SD, fx-9860G II , fx-9860G AU PLUS, fx-9750G II , fx-7400G II ,
fx-9860G Slim (OS 1.11), fx-9860G SD (OS 2.00), fx-9860G (OS 2.00), fx-9860G AU (OS
2.00), CFX-9850G series