Casio FX-CG10 - Page 42

1-35
u Slope (display of derivative at current pointer location in conic section
graph)
• { On } / { Off } ... {display on}/{display off}
u
Payment
(payment period setting)
• { BEGIN } / { END } ... {beginning}/{end} setting of payment period
u
Date Mode
(number of days per year setting)
• { 365 } / { 360 } ... interest calculations using {365}/{360} days per year
u
Periods/YR.
(payment interval specification)
• { Annual } / { Semi } ... {annual}/{semiannual}
u Graph Color
• {Black}/{Blue}/{Red}/{Magenta}/{Green}/{Cyan}/{Yellow} ... Specifies a single line color
for graphing in the Financial mode.
u Ineq Type (inequality fill specification)
• { Intsect } / { Union } ... When graphing multiple inequalities, {fill areas where all inequality
conditions are satisfied}/{fill areas where each inequality condition is satisfied}
u Simplify (calculation result auto/manual reduction specification)
• { Auto } / { Manual } ... {auto reduce and display}/{display without reduction}
u Q1Q3 Type (Q
1
/Q
3
calculation formulas)
• { Std } / { OnData } ... {divide total population on its center point between upper and lower
groups, with the median of the lower group Q1 and the median of the upper group Q3}/
{make the value of element whose cumulative frequency ratio is greater than 1/4 and
nearest to 1/4 Q1 and the value of element whose cumulative frequency ratio is greater
than 3/4 and nearest to 3/4 Q3}
u Auto Calc (spreadsheet auto calc)
• { On } / { Off } ... {execute}/{not execute} the formulas automatically
u Show Cell (spreadsheet cell display mode)
• { Form } / { Val } ... {formula}*
1
/{value}
u Move (spreadsheet cell cursor direction) *
2
• { Low } / { Right } ... {move down}/{move right}
*
1
Selecting “Form” (formula) causes a formula in the cell to be displayed as a formula. The
“Form” does not affect any non-formula data in the cell.
*
2
Specifies the direction the cell cursor moves when you press the w key to register cell
input, when the Sequence command generates a number table, and when you recall data
from List memory.