76
QR CODE Enable
[Enable], [Disable], [Details]
REDUCED SPACE
SYMBOLOGY
Enable
[Enable], [Disable], [Details]
UPC A Enable
[Enable], [Disable], [Details]
UPC E Enable
[Enable], [Disable], [Details]
STRAIGHT 2 OF 5 (IATA) Disable
[Enable], [Disable], [Details]
CODABLOCK F Disable
[Enable], [Disable], [Details]
MSI Disable
[Enable], [Disable], [Details]
TCIF LINKED CODE 39
(TLC39)
Disable
[Enable], [Disable], [Details]
TRIOPTIC CODE 39 Disable
[Enable], [Disable], [Details]
CODE 32 PHARMACEUTICAL
(PARAF)
Disable
[Enable], [Disable], [Details]
MATRIX 2 OF 5 Disable
[Enable], [Disable], [Details]
TELEPEN Disable
[Enable], [Disable], [Details]
GS1 128(EAN 128) Enable
[Enable], [Disable], [Details]
ISBT 128 Disable
[Enable], [Disable], [Details]
STRAIGHT 2 OF 5 (IATA) Disable
[Enable], [Disable], [Details]
UCC COUPON Disable
[Enable], [Disable], [Details]
HAN XIN Disable
[Enable], [Disable], [Details]
UPC E1 Disable
[Enable], [Disable], [Details]
CHINA POST Disable
[Enable], [Disable], [Details]
KOREAN 3 OF 5 Disable
[Enable], [Disable], [Details]
AUSTRALIA POST Disable
[Enable], [Disable], [Details]
BRITISH POST(BPO) Disable
[Enable], [Disable], [Details]
CANADIAN POST Disable
[Enable], [Disable], [Details]
USPS 4CB Disable
[Enable], [Disable], [Details]
JAPAN POSTAL Enable
[Enable], [Disable], [Details]
NETHERLANDS KIX CODE Disable
[Enable], [Disable], [Details]
US PLANET Disable
[Enable], [Disable], [Details]
UPU FICS POSTAL Disable
[Enable], [Disable], [Details]
US POSTNET Disable
[Enable], [Disable], [Details]
This “Scansettng” can change the setting of various barcodes, but the barcodes not
supported by IT-G400 are also included in the list. Please refer to 2.20 Barcode
scan
ner (p. 33) for the barcode that supports.
Select
“Symbologies”, and tap on each barcode to switch to the detailedsetting screen.
On the detailed setting screen, you can set the number of digits to read barcode and
enable / disable of character calculation. Please refer to the Device Library Manual for
possible values of each setting.
Do not change the Barcode ID for each barcode. Discrimination after barcode reading
will not operate properly.
Depending on the specification of the barcode scanner module, it is not possible to
specify more than one POSTAL code. And, at least one POSTAL code must be enabled.
The default for IT-G400 is JAPAN POSTAL.
To Next Page
Loading...
