92
9. Reset switch
There are two ways to reset the IT-G400.
(1) Press power switch for 12 seconds
Close the file at the Linux level and reboot terminal.
(2) Push reset switch
Forcibly turn off the system power. It does not close the file etc.
Resetting with the reset switch can cause inconsistency of the file. Therefore, if you want to restart
the terminal, recommend that you try in the following order.
1. Press the power key for 1 second and select "Restart" from the pop-up.
2. Press and hold the power key for 12 seconds.
3. Press the reset switch.
Reset
switch
Reset
switch
To Next Page
Loading...
