E-13
Operating Precautions
Your tablet and its options are precision. Improper operation or rough handling can
cause problems with data storage and other problems. Note and observe the following
precautions to ensure proper operation.
Do not leave dead battery pack in the tablet for a long period.
Dead battery pack can leak, leading to malfunction and damage to the tablet.
Stop or avoid using the tablet and its options in areas and conditions subject to
the following.
— Large amounts of static electricity
— Extreme heat or cold or humidity
— Sudden temperature change
— Large amount of dust
— After large amount of rain or water falls on the tablet
— Pressing the screen or buttons with excessive force when using in the rain
Always use your fi nger or the dedicated Digitizer Pen when using the touch
panel. The use of implements other than your fi nger or the dedicated Digitizer
Pen could damage the touch panel and/or cause malfunctions.
Do not use the Digitizer Pen when your hands are wet.
Do not use volatile chemical substances such as thinners, benzene or toiletries to
clean the tablet.
When the tablet is dirty, wipe it clean with a soft, dry cloth. Rubbing with excessive
force could scratch the display.
The power-supply terminals and charging terminals should be cleaned from
time to time using an implement such as a dry cotton bud.
Soiling on the terminals may cause connection defects.
Take care when using chemicals.
Applying thinners, gasoline, kerosene, solvents or oils, or substances such as cleaners,
adhesives, paints, medications or toiletries that contain those materials, to the plastic
case or cover may cause discoloration or other damage.
Allowing the communication/power supply terminals become wet can cause an
electric shock or fi re. In addition, if the terminals become soiled, contact may
be impaired resulting in poor charging. For reasons of safety and maintaining
charging battery pack(s) in optimum condition, clean the communication/power
supply terminals by wiping with a dry cloth or cotton swab after disconnecting
the AC adaptor.
•
•
•
•
•
•
•
•
To Next Page
Loading...
General