E-42
Using SIM Cards
This tablet supports SIM cards.
SIM cards may not be supported by some models. See E-21 for information on
compatible models.
The card slot is located in the battery pack compartment (see E-20, 21). Remove the
battery pack before inserting or removing a card.
Refer to pages 22 to 24 for information on “Loading and Removing the Battery Pack”.
Install (or remove) a card according to the procedure described below.
Installing
1. Make sure that the power on the tablet has been switched off. If the power is still on,
hold down the power button to switch off (see E-27).
2. Remove the battery pack.
3. Open the supporting cover.
4. Check that the card is the right way up and facing in the right direction, then match it
to the correct printed icon and push it into the slot.
Insert the card so that the notch is on the front right corner.
5. Close the supporting cover and push the inserted card just above the cover.
Push the card in fully until it clicks into place.
6. Load the battery pack.
•
•
To Next Page
Loading...
General