E-38
Using microSD Cards
This tablet supports microSD cards.
The card slot is located in the battery pack compartment (see E-20, 21). Remove the
battery pack before inserting or removing a card.
Refer to pages 22 to 24 for information on “Loading and Removing the Battery Pack”.
Install (or remove) a card according to the procedure described below.
Installing
1. Make sure that the power on the tablet has been switched off. If the power is still on,
hold down the power button to switch off (see E-27).
2. Remove the battery pack.
3. Check that the card is the right way up and facing in the right direction, then match it
to the correct printed icon and push it all the way into the slot.
Turn the card so that rear side (with the terminals) faces upwards and then push the
card in fully until it clicks into place.
4. Load the battery pack.
Removing
1. Make sure that the power on the tablet has been switched off. If the power is still on,
hold down the power button to switch off (see E-27).
2. Remove the battery pack.
•
To Next Page
Loading...
General