Catler ES 910 - Preparing the Coffee Machine es 910 for Use; Before First Use; Filling the Water Tank

12
PREPARING THE COFFEE MACHINE ES 910 FOR USE
PREPARING THE COFFEE MACHINE ES 910 FOR USE
BEFORE FIRST USE
Before rst use, remove all packaging and advertising labels/stickers from the appliance.
Remove the water tank and the drip tray with the grid from the coee machine.
Wash the water tank, drip tray, grid, tamper, handle and strainers in warm water with alittle
dishwashing detergent. Rinse in clean water and wipe dry.
Put the water tank and drip tray back into the coee machine.
Place the handle, strainers and tamper on the cup warming surface.
Wipe the outer surface of the coee machine, including the hopper on the coee machine,
with aslightly damp cloth and wipe dry with aclean cloth.
FILLING THE WATER TANK
1. Take the water tank by the handle and pull it up.
2. Fill the water tank with clean water up to the maximum mark and insert it back into the
appliance. Make sure the tank is properly installed in place.
The water should ideally be at room temperature (around 25°C). Water that is too cold can
adversely aect the nal taste of the coee drink.
Do not leave the water in the tank for more than one day. For brewing quality fresh coee, it
is necessary to always use fresh water. Otherwise, the taste of the resulting beverage may be
adversely aected.
WARNING!
THE MAXIMUM TANK CAPACITY IS 2.5
LITRES OF WATER. DO NOT OVERFILL IT. NEV

ER FILL THE TANK WITH WARM, HEATED OR
SPARKLING WATER OR OTHER LIQUIDS SUCH
AS MILK. THIS COULD DAMAGE THE APPLI

ANCE. DO NOT FILL THE TANK WITH WATER
WHEN IT IS INSERTED IN THE COFFEE MA

CHINE.