Catler ES 910 - Refilling the Water Tank; Warning for Full Drip Tray

24
USING THE COFFEE MACHINE ES 910
WARNING!
THE TEMPERATURE OF THE STEAM IS
VERY HIGH AND THERE IS ARISK OF SERIOUS
BURNS IF IMPROPERLY HANDLED.
NOTE:
The steam dispensing time is approximately 2 minutes. After that, the steam
dispensing stops automatically. Turn the steam/hot water dispensing control to
position 0. This is aprotective function against overheating of the internal system and
consequent damage to the coee machine.
NOTE:
The temperature of the water/steam in the steam jet is higher than the temperature
dispensed through the brew head. Therefore, after using the steam jet (both for
dispensing hot water and frothing milk), the excess hot water is released into the drip
tray. This prevents the ground coee in the strainer from being burnt by excessively hot
water. This is anormal occurrence.
REFILLING THE WATER TANK
If the tank runs out of water during use, the , and buttons will ash and “EP” appears
on the grinding time display.
Rell the water tank according to the instructions in the section “Filling the Water Tank”.
NOTE:
The grinding time display will also show “EP” if you use too ne ground coee. In this
case, water will not be able to ow through the coee. An audible warning will sound 5
times. If you do not take any action within 1 minute, the coee machine will switch to
standby mode.
WARNING FOR FULL DRIP TRAY
The drip tray is equipped with aoat. When the water level in the drip tray is too high,
the oat will rise above the hole in the grid, it is necessary to pour out the water to avoid
overowing the drip tray.