Catler ES 910 - Using the Coffee Machine es 910; Switching the Coffee Machine on and off; Automatic Shut-Off of the Coffee Machine; Preheating the Coffee Machine

20
USING THE COFFEE MACHINE ES 910
USING THE COFFEE MACHINE ES 910
SWITCHING THE COFFEE MACHINE ON AND OFF
Before switching the coee machine on, check that:
– The coee machine is correctly assembled and no parts are damaged.
– Water is in the tank and the lid is closed.
– The hopper is lled with coee beans and the lid is in place.
– The drip tray is empty and the grid is correctly tted on the tray.
Insert the power plug into apower socket, ashort beep sounds and the control panel lights
up briey.
Switch on the coee machine by briey pressing the button. The internal system preheat to
operating temperature is started.
If you need to switch o the coee machine, press the button briey. To switch the
appliance completely o, unplug the power cord from the socket.
AUTOMATIC SHUTOFF OF THE COFFEE MACHINE
The coee machine is equipped with an automatic shut-o function. If you do not perform
any activity within 30 minutes, the coee machine will automatically switch o and go into
standby mode.
Press the button to switch the machine on. The internal system will start heating up to
operating temperature.
PREHEATING THE COFFEE MACHINE
The coee machine preheats automatically when the coee machine is switched on by
pressing the button, if the temperature in theheaters drops below the set temperature. It is
important to heat up the internal system and components to operating temperature in order
to prepare aquality cup of coee.
During the preheating of the coee machine, the and
, and buttons will ash. Once
the buttons stop ashing and light up, the coee machine is preheated and ready to use.
IMPORTANT:
If the button starts to ash during preparation, it means that the temperature in the
steam jet heater has dropped and needs to be reheated. Wait for the
button to light up.
If the button starts to ash during preparation, the temperature in the coee brewing
heater has dropped and needs to be warmed up. Wait for the button to light up.
NOTE:
If the coee machine detects that the temperature in the heaters is high enough to
ensure reliable operation, the preheating phase is automatically skipped and the coee
machine can be used.