Catler ES 910 - Cleaning the Steam Jet; Cleaning the Water Tank; Cleaning the Drip Tray

29
CARE AND CLEANING
CLEANING THE STEAM JET
1. After frothing the milk, wipe the end of the steam jet with asoft sponge slightly
dampened with warm water.
2. Direct the steam jet away from the opening in the drip tray grid and run the steam
dispensing for afew seconds to remove any milk residue from the steam jet. Then wipe
with adry cloth.
WARNING!
NEGLECTING TO CLEAN THE STEAM
JET CAN CAUSE IT TO BECOME BLOCKED AND
CLOGGED, AS WELL AS THE FORMATION OF
UNWANTED ORGANISMS THAT CAN SPOIL
THE NEXT DOSE OF FROTHED MILK AND
CAUSE SERIOUS HEALTH PROBLEMS.
CLEANING THE WATER TANK
Clean the water tank regularly. Do not leave the water in the tank for more than one day.
1. Take the water tank by the handle and pull it up.
2. Pour out the remaining water from the tank.
3. Flush the water tank with clean water. If necessary, use asoft sponge to wipe the inner
walls of the tank. Rinse and wipe dry with aclean cloth.
4. Insert the tank back into the appliance. Make sure the tank is properly installed in place.
CLEANING THE DRIP TRAY
Empty and clean the drip tray and grid regularly. The drip tray is equipped with aoat. When
the water level in the drip tray is too high, the oat will rise above the hole in the grid, it is
necessary to pour out the water to avoid overowing the drip tray.
1. Carefully pull the drip tray out of the body of the machine.
2. Remove the grid.
3. Pour out the contents of the drip tray.
4. Wash the grid and drip tray in warm water with alittle dishwashing detergent, rinse and
wipe dry with aclean cloth.
5. Insert back into the coee machine.