Catler ES 910 - Cleaning the Grinder

32
CARE AND CLEANING
Descaling Process
1. Place the bowls of at least 1 litre each under the brew head and steam jet.
2. Make sure that the steam/hot water dispensing control is in position 0.
3. Press the
button for about 2 seconds.
4. The grinding time display shows “d1”.
5. Turn the steam/hot water dispensing control to .
6. The grinding time display shows “d2” and the coee machine starts dispensing the
descaling solution. The solution will ow through both jets and the brew head. The
hot water dispensing time will be approximately 3 minutes. Ashort beep will be heard
periodically.
7. When the hot water dispensing through the steam jet stops, the grinding time display
shows “d3”.
8. Remove the water tank. Rinse it with cold water and pour fresh water in up to the
maximum mark. Put the tank back in the coee machine.
9. Press the button and the grinding time display will show “d4”.
10. The coee machine starts dispensing hot water through both jet and the brew head. The
water dispensing time will be approximately 2 minutes.
11. The descaling process is complete and the coee machine will then return to the state
where it is ready to make coee.
12. Turn the steam/hot water dispensing control to position 0.
CLEANING THE GRINDER
Clean the grinder regularly to remove old coee residue. Old coee beans can go rancid,
which can negatively aect the preparation and taste of your coee.
Filling the Coffee Bean Hopper
Clean the coee bean hopper whenever you transfer unused beans into the airtight container
or before pouring in new coee beans.
1. Remove the lid of the coee bean hopper.
2. Release the hopper lock and remove the hopper from the coee machine.
3. Transfer the remaining coee beans into an airtight container.
4. Wipe the tray and lid with asoft sponge slightly dampened in warm water. Wipe dry with
aclean cloth.
Cleaning the Grinder
1. Remove and empty the coee bean hopper.
2. Remove the upper grinding stone.