22
USING THE COFFEE MACHINE ES 910
11. The hot water is then dispensed into the cup. Pour approximately the same amount of
water into the cup as the prepared coee.
12. Take acup and enjoy your coee.
13. Release the handle from the brew head and clean it according to the instructions in the
section “CARE AND CLEANING”.
HOT WATER DISPENSING HOT WATER DISPENSING JET
1. Switch on the coee machine and allow it to preheat suciently.
2. Place acup or cups under the hot water jet.
3. Press the button repeatedly, select the coee types “PRESSURE HOT WATER” and the
indicator lamp lights up.
4. Press the button briey to start the hot water dispensing process.
5. To stop the hot water dispensing, press the button again.
6. Take the cup away.
NOTE:
The maximum hot water dispensing time is 2 minutes. After that, water dispensing
will automatically stop. This is aprotective function against overheating of the internal
system and consequent damage to the coee machine.
HOT WATER DISPENSING STEAM JET
1. Press the button repeatedly until the HOT WATER indicator lamp lights up.
2. Direct the steam jet into the hole in the drip tray grid.
3. Turn the steam/hot water dispensing control to .
4. Allow the water to ow for afew seconds to clean o any dirt and heat it up.
5. Turn the steam/hot water dispensing control to position 0.
6. Now insert the steam jet into the cup.
7. Turn the steam/hot water dispensing control to .
8. The hot water dispensing starts.
9. Once the desired amount of water ows into the cup, turn the steam/hot water dispensing
control to position 0. The water dispensing will stop.
10. Wipe the end of the steam jet with aslightly dampened sponge.
NOTE:
The maximum hot water dispensing time is 2 minutes. After that, water dispensing
will automatically stop. Turn the steam/hot water dispensing control to position 0. This
is aprotective function against overheating of the internal system and consequent
damage to the coee machine.
To Next Page
Loading...
