Catler ES 910 - Care and Cleaning; Clean after Every Use; Cleaning the Handle and Strainer

28
CARE AND CLEANING
CARE AND CLEANING
Before cleaning the appliance, always disconnect the plug of the power cord from the mains
socket and let it to cool down properly.
WARNING!
DO NOT WASH THE APPLIANCE, MAINS
CORD AND PLUG UNDER RUNNING WATER
AND DO NOT IMMERSE IT IN WATER OR ANY
OTHER LIQUID.
WARNING:
Do not use sharp objects, chemicals, thinners, petrol or other similar substances. Under
no circumstances should the appliance be cleaned with asteam cleaner.
CLEAN AFTER EVERY USE
The following cleaning steps must be performed after each use.
CLEANING THE HANDLE AND STRAINER
1. Remove the handle from the brew head by turning the grip of the handle to the left until
the grip is aligned with the “INSERT” inscription on the brew head. Then, in adownward
motion, remove the handle from the brew head.
2. Dispose of the coee grounds in your mixed waste or home composter.
3. Remove the strainer from the handle. If the strainer is dicult to remove, insert the cutlery
knife into the space between the strainer and the handle and lift the strainer with the
knife.
4. Wash the handle and strainer in warm water and then wipe dry with aclean cloth.
5. Place the handle and strainer on the surface to heat the cups to keep them warm.
WARNING!
THE HANDLE AND STRAINER ARE VERY
HOT AFTER USE AND THERE IS ARISK OF SE

RIOUS BURNS IN CASE OF IMPROPER HAN
DLING. THEREFORE, BE VERY CAREFUL WHEN
CLEANING THE HANDLE AND STRAINER.