Catler ES 910 - Page 8

8
CATLER RECOMMENDS SAFETY FIRST
• Before connecting the appliance to apower socket, check that the nominal voltage on the
appliance'srating label matches the electrical voltage in the socket.
• Connect the appliance only to agrounded socket. For safety reasons, we do not
recommend using adaptor plugs or extension cords.
• Do not place the appliance on windowsills, sink drip tray or on unstable surfaces. Always
place the appliance on astable, at and dry surface.
• Do not place the appliance on electric or gas cooker or in the vicinity of naked ame.
• Never use the appliance in the near vicinity of abath, shower or swimming pool.
• Use the appliance only for the purpose for which it has been designed.
• Use the appliance according to the instructions in this user'smanual. Otherwise injury,
damage to the appliance or dangerous situation might occur.
• Only use the appliance with the original supplied accessories.
• During operation, aclear space of at least 15 cm must be left around and above the
appliance to ensure sucient air circulation.
• Only use the top surface of the appliance for warming cups. Do not use it to store items.
• Fill the water tank with clean, cold water. Do not pour hot water or other liquids into it or
place any objects inside it.
• Before switching on the appliance, check that:
– the drip tray together with the grid is installed in position;
– the water tank is lled with asucient amount of water and is properly installed in
position.
• The water level must not exceed the maximum mark.
• Take great care when operating the appliance to avoid scalding with hot water or steam.
• The hot water function may only be used continuously for amaximum of one emptying of
the entire water tank.
• When using the appliance, check the water level in the water tank regularly. If the water
level falls below the minimum mark, rell the water tank. Before adding water, rst switch
the appliance o and disconnect it from the power socket.
• Use the built-in coee grinder only for grinding coee beans. Do not use it for any other
purposes.
• Ensure that no hair or other items enter the grinder area during the grinding process. •
The coee bean hopper lid should always be properly closed unless you are relling coee
beans or adjusting the grinding coarseness.
• The appliance is equipped with abuilt-in thermal fuse that shuts it o when the pump is
idling to prevent damage. If such asituation occurs, unplug the power cord and allow the
appliance to cool down for at least 30 minutes. Then you can use it again.
• Do not move the appliance with acup of coee placed on the drip tray grid or with cups
placed on the surface designed to warm them up.
• Ensure that the power cord does not come into contact with ahot surface.
• When disconnecting the appliance from the power socket, always pull the plug, not the
power cord. Otherwise, damage to the power cord or the socket may occur.