- 24 -
8-3-6. Precautions while processing the data
① Decimal point position of each data is clearly mentioned in the reference table. There are various
points like fixing the decimal point position, points to be decided for every measurement range
(See section 8.9) items as per linear decimal point setting. Take care about the decimal point
position when data is regenerated.
② As every data can be accessed (changed), it is necessary to take care at the time of setting the
related data. For example, there exists data initialization process etc. depending on the change in
the measurement range. Process contents are mentioned in reference number table.
③ Read and write the data in the range of the numbers, specified by reference number. If data is
read and written for the reference numbers that are not specified, device operation may get
affected.
④ Many reference numbers that are not continuous can be read and written, however, if the
reference number that is not specified is the starting number than it is an error (Error-02H).
⑤ When reading a number of reference numbers, the data of the number that is not specified by the
reference number becomes '0'.
⑥ When writing multiple reference numbers, if an error is detected all the settings become disabled.
To Next Page
Loading...
Need help?
General
