Chino KP3000 User Manual

- 71 -
Code Error type Contents
36
Select pattern OP
･Select pattern selected the pattern in case of KEY or ETX
40
Set pattern
･Set the pattern except for RESET.
41
〃 ･Continued 2 steps and set Time=0.
43
〃 ･Set parameter No. in unset step (END step).
44
〃 ･Did repeat setting in unset step.
45
〃 ･Set after END step. (Add)
46
〃 ･Set END after unset step.
50
Copy pattern
･Copy pattern except in case of RESET.
51
〃 ･Copy destination is not cleared.
52
〃 ･Copy source pattern is not set.
53
Clear pattern
･Clear pattern except during RESET.
54
Read pattern
･Read requested the pattern data except during RESET.
55
〃 ･Read requested the unset step.
60
RUN; PTN No.
･Unset pattern is RUN. (Link destination includes the unset
pattern)
61
RUN; Repeat step
･Repeat step setting of the pattern that was RUN is an error
65
AT start
･Started AT1 during RESET, PRG.
66
〃 ･Started AT2 except for RESET, PRG.
67
〃 ･Started AT3 except for RESET, PRG.
99
Others
･At the time of other error

Chino KP3000 Specifications

General

Brand	Chino
Model	KP3000
Category	Controller
Language	English