LCR Meter 11021 / 11021-L User’s Manual
4-2
(5) MEAS DISPLAY
Upon pressing this key, the instrument is in basic component measurement & analysis
mode. In this screen, each test parameter can be changed directly and the value read
such as test frequency, test voltage, measurement parameter, measurement speed, test
loops (series or parallel)…etc.
(6) MAIN INDEX
Pressing this key allows entry to the main index screen. In this screen you may select
the test function you wish to use, for instance the DUT test result sorting function, open
test, short test, comparing function…etc.
(7) SYSTEM SETUP
Pressing this key gives access to the main system parameters setup screen, which
allows each system parameter to be changed directly, e.g., the calibration of this
instrument, memory management, selection and setting parameters of each system
and measurement parameters. (The functions of calibration and memory-management
require a password for entry).
(8) Cursor
There are [], [], [], and [] four arrow keys. These keys are for display in different
conditions and control cursor, which can be useful when inputting each parameter.
They can also be used as selection keys; for instance use [], [] to change the range,
also use [], [] to set the frequency or voltage.
(9) Trigger
This is the key to trigger the measurement for start. When the measurement is in
manual state, press this key can do the measurement once.
(10) Isolation Terminal
This terminal connects to the case of the instrument. Connect this terminal to the
isolation area of DUT to avoid the test value from interfering by external signal that may
affect its accuracy.
To Next Page
Loading...
