Chroma 61503 - Page 100

Programmable AC Source 61501/61502/61503/61504 User’s Manual
8-18
[SOURce :] LIST : BASE
Description : This command sets time base of list.
Query Syntax : [SOURce:] LIST : BASE?
Parameters : TIME | CYCLE
Return Parameters : TIME | CYCLE
[SOURce :] LIST : VOLTage : AC : STARt
Description : This command sets the sequence of AC start voltage list
points.
Query Syntax : [SOURce:] LIST : VOLTage : AC : STARt?
Parameters : <NR2>, …, <NR2> valid range: 0.0 ~ 150.0 (in low range), 0.0
~ 300.0 (in high range)
Return Parameters : <NR1>, …, <NR2>
[SOURce :] LIST : VOLTage : AC : END
Description : This command sets the sequence of AC end voltage list points.
Query Syntax : [SOURce:] LIST : VOLTage : AC : END?
Parameters : <NR2>, …, <NR2> valid range: 0.0 ~ 150.0 (in low range), 0.0
~ 300.0 (in high range)
Return Parameters : <NR2>, …, <NR2>
[SOURce :] LIST : VOLTage : DC : STARt
Description : This command sets the sequence of DC start voltage list
points.
Query Syntax : [SOURce:] LIST : VOLTage : DC : STARt?
Parameters : <NR2>, …, <NR2> valid range: -212.1 ~ 212.1 (in low range),
-424.2 ~ 414.2 (in high range)
Return Parameters : <NR1>
[SOURce :] LIST : VOLTage : DC : END
Description : This command sets the sequence of DC end voltage list points.
Query Syntax : [SOURce:] LIST : VOLTage : DC : STARt?
Parameters : <NR2>, …, <NR2> valid range: -212.2 ~ 212.1 (in low range),
-424.2 ~ 414.2 (in high range)
Return Parameters : <NR2>, …, <NR2>
[SOURce :] LIST : FREQuency : STARt
Description : This command sets the sequence of start frequency list points.
Query Syntax : [SOURce:] LIST : FREQuency : STARt?
Parameters : <NR2>, …, <NR2> valid range: 15.00 ~ 1000.00 (unit: Hz)
Return Parameters : <NR2>, …, <NR2>
[SOURce :] LIST : FREQuency : END
Description : This command sets the sequence of end frequency list points.
Query Syntax : [SOURce:] LIST : FREQuency : END?
Parameters : <NR2>, …, <NR2> valid range: 15.00 ~ 1000.00 (unit: Hz)
Return Parameters : <NR2>, …, <NR2>
[SOURce :] LIST : DEGRee
Description : This command sets the sequence of phase angle list points.
Query Syntax : [SOURce:] LIST : DEGRee?
Parameters : <NR2>, …, <NR2> valid range: 0.0 ~ 359.9
Return Parameters : <NR2>, …, <NR2>