Chroma 61503 - Page 101

Remote Operation
8-19
OUTPut : MODE
Description : This command sets the operation mode.
Query Syntax : OUTPut : MODE?
Parameters : FIXED | LIST | PULSE | STEP | SYNTH | INTERHAR
Return Parameters : FIXED | LIST | PULSE | STEP | SYNTH | INTERHAR
TRIG
Description : This command sets LIST mode in OFF, ON execution state
after setting OUTPut : MODE LIST. If users want to change
the parameters, it’s necessary to set TRIG OFF then OUTPut :
MODE FIXED. Then, set OUTPut : MODE LIST again to get
ready to set TRIG ON.
Query Syntax : TRIG : STATE?
Parameters : OFF | ON
Return Parameters : OFF | RUNNING
8.6.2.8 PULSE Sub-system
[SOURce :]
PULSe
: VOLTage
: AC
: DC
: FREQuency
: SHAPe
: SPHase
: COUNt
: DCYCle
: PERiod
OUTPut
: MODE
TRIG
TRIG : STATE?
[SOURce :] PULSe : VOLTage : AC
Description : This command sets AC voltage in the duty cycle of PULSE
mode.
Query Syntax : [SOURce :] PULSE : VOLTage : AC?
Parameters : <NR2>, valid range: 0.0 ~ 150.0 (in low range), 0.0 ~ 300.0 (in
high range)
Return Parameters : <NR2>
[SOURce :] PULSe : VOLTage : DC
Description : This command sets the DC voltage in the duty cycle of PULSE
mode.
Query Syntax : [SOURce :] PULSE : VOLTage : DC?
Parameters : <NR2>, valid range: -212.1 ~ 212.1 (in low range), -424.2 ~
424.2 (in high range)
Return Parameters : <NR2>