Chroma 61603 - Saving and Recalling System Data

Programmable AC Source 61601/61602/61603/61604 User’s Manual
3-24
Press 1 - 3 to choose one group to save, then press ENTER to confirm. The display
will show the saving status sentence about three seconds as below.
Then, press PAGE/EXIT to return to CHOICE PAGE.
Recalling system data from memory group is shown the following: In CHOICE PAGE, press
SHIFT then

/ - to run the RECALL function. The display will show as below:
Press 1 - 3 to choose one group to recall, then press ENTER to confirm. Then, the
display will return to CHOICE PAGE after loading the data.
The AC source provides three memory groups: 1, 2, and 3. The memory
group 1 keeps power-on defaults. The setup data saved into memory
group 1 will be recalled automatically when the AC source is powered on
again. Those saved into other memory groups must be recalled
manually.
Save all parameters to Group ( 1 -
3 ) : 1_
Save all parameters to Group ( 1 -
3 ) : 1_
Saving now, do not shut down ........
PAGE CHOICE = 1_
1. SETUP 2.CONF 3.OUTPUT 4. MANUAL CALI
Recall parameters of Group ( 1 -
3 ) : 1_