Chuango G5 - Password and Single Zone Delay Settings

Delete wireless sensors successfully.
29
30
Restore system to default setting
Also called a ‘hard reset’. This should also be performed when changing the SIM card.
0000
0000
A hard reset can also be performed by pushing 5 times within 3 seconds on the
tamper switch at the backside of the control panel.
SMS notification of low battery sensors
Note: The administrator receives a SMS message when the battery level is low. The message exists
(until sensor 9) out of the sensor name supplemented with the message ‘low battery’. The message
for sensor 10 and higher will be the sensor number supplemented with ‘low battery’.
SMS notification of tampering sensors
Note: this feature applies to sensors with a built-in tamper switch. You will receive a message when
a sensor is sabotaged. The message exists (until sensor 9) out of the sensor name supplemented
with the message ‘tamper alarm’. The message for sensor 10 and higher will be the sensor number
supplemented with ‘tamper alarm’.
21
Delete wireless sensors by SMS
All accessories (wireless sensors, RFID tags and remote controls) can be removed from
the system by pressing the tamper switch 3 times within 3 seconds. The control panel
will sound two beeps when the accessories are removed. When removing the wireless
sensors separatelyby SMS, text ‘21’.
Delete all RFID tags by SMS & App
All RFID tags can be removed by texting ‘22’ to the SIM card number in the control
panel.
22
In the App it can be found in the menu:
Delete all remote controls by SMS
All remote controls can be removed by texting ‘23’ to the SIM card number in the
control panel.
23
Delete RFID tags successfully.
Delete remote controls successfully.
PIR-900 Wireless PIR Motion Detector
1.
2.
3.
1.
2.
3.
IMPORTANT: When single zone group is selected, the sensor will always be in
the normal group. It is not possible to place it in the home group.
3 Years
Warranty