Chuango G5 - Remote control; Arm and Disarm Operations; Special Modes and Emergency Call; Connecting a New Remote Control

37
38
Test mode PIR motion detector
Once the motion detector is fully installed and active, the detector can be tested. Press
the test button once and walk from left to right or right to left in the room.
The LED indicator will flash once when motion is detected.
Adjust the angle of the motion detector if needed to obtain the best results. Repeat
step 1 and 2 to test the new angle.
1.
2.
3.
2m
4m
6m 8m0m
0m
2m
110°
Top view
Side view
Front view door/window contact
Wireless Door/Window Contact
LED Status Indicator
Transmitter
Magnet
Floor
Installing PIR motion detector
Avoid installing the motion detector directly toward windows, near airconditioning,
heating, refrigerator, oven, direct sunlight and places where many temperature
fluctuations occur. Also try to avoid placing two motion detectors in the opposite of
each other; don’t place it in each others detection range.
Mount the bracket with the included screws as shown in the figure on
the left. Then place the motion detector in the bracket. Specify the
right direction of the detection range of the motion sensor. Test the
operation of the motion detector by putting it into testing mode
which is described at the former page.
Side view
Top view
IMPORTANT: If pet-immune function is used, please do not adjust the angle up
or down.
Note: The ideal mounting height of the motion detector is 2.2 meters from the floor.
2.2m
PIR-900 Wireless PIR Motion Detector
1.
2.
3.
1.
2.
3.
IMPORTANT: When single zone group is selected, the sensor will always be in
the normal group. It is not possible to place it in the home group.
3 Years
Warranty