45
46
Troubleshooting
When the G5 alarm system is not working properly please try following solutions:
Reason/Solution
Confirm whether the power supply is connected correctly
Make sure the power is on
Check whether the indicator on the remote control is on
when pressing
Check whether the remote control has paired to the control
panel successfully
The distance between the control panel and the remote
control is too far away
Check whether the LED indicator is on when magnetic
separates from transmitter
Door/window contact is far away from the control panel
Check whether the system is in armed state
Check whether space between the magnet and
transmitter is within 1 cm
Press the test button of the detector continuously in
armed state. If the control panel does not alarm, please
re-pair the PIR to the control panel
The detector is far away from the control panel
Check if the detector has entered sleeping state
Check if the battery is exhausted
The control panel
cannot start up
Remote control
does not work
Door/window
contact does not
work
The PIR detector is
triggered but the
control panel does
not alarm
Problems
RC-80 Wireless Remote Control
Power Supply
Transmit Current
Wireless Transmitting Distance
Radio Frequency
Housing Material
Temperature
Relative Humidity
Dimensions
DC 3V
(one CR2025 button cell battery)
≤ 7mA
≤ 80 m (open field/no interference)
315MHz or 433.92MHz (±75MHz)
ABS+PC plastic
-10 to +55 degrees celcius
≤ 80% (non-condensing)
58 x 31 x 9.5mm
TAG-26 (RFID tag)
Circuit
Radio Frequency
Wireless Transmitting Distance
Dimensions
EM4100 CMOS
125KHz
≤ 80 m (open field/no interference)
30 x 30 x 6mm
Electrical products should not be discarded with household products. According to the
European Directive 2002/96/EC on waste electrical and electronic equipment and its
implementation into national law, electrical products used must be collected separately
and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
BATTERY TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
PIR-900 Wireless PIR Motion Detector
1.
2.
3.
1.
2.
3.
IMPORTANT: When single zone group is selected, the sensor will always be in
the normal group. It is not possible to place it in the home group.
3 Years
Warranty
To Next Page
Loading...
