33
34
Pet-Immune PIR Motion Detector
PIR motion detector overview
1. Detection window
2. LED indicator
3. Wall mount
LED indicator
Blink continuously
Blink once
Blink twice
Blink once every 3 seconds
: Motion detector performs a self-testing
: Motion detected
: 3 minutes testing is finished, enters power saving mode.
: Low battery indication, please change the batteries
immediately.
Note: When battery level is low it will send an SMS message for notification.
2
1
Home mode
Press . All sensors in the normal group will be
activated. All sensors in the home group will be
inactive. This means you can partially arm the house.
Mute mode
Press and hold the for 1 second, and then press or
within 3 seconds. The alarm system will be armed or
disarmed without making any noise. The alarm system
can be control without disturbing fellow residents.
Emergency call
Regardless whether the alarm system is armed or
disarmed, by pressing the button on the remote SOS
control the alarm will be activated immediately.
Connect a new remote control
Enter the password on the control panel and press the button. The button lights
up. Press a button on the remote control to connect with the controle panel. The
control panel will beep once when paired successfully. It will beep twice when it has
already been paired before.
PIR-900 Wireless PIR Motion Detector
1.
2.
3.
1.
2.
3.
IMPORTANT: When single zone group is selected, the sensor will always be in
the normal group. It is not possible to place it in the home group.
3 Years
Warranty
To Next Page
Loading...
