3-6 Turning Up the System
5150 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3222-001 Standard Revision H
Copyright
©
2012-2015 Ciena
®
Corporation July 2015
• At least one character must be alpha (a-z) or a dash (-).
• Host name is case sensitive.
• The following special characters are not allowed: “ % * ? !
For a procedure see “Setting the System Host Name” on page 3-17.
Logging Out of the System
When you have completed your initial system configuration, you can log out
of the system and remove the connection to the serial console port.
Note: Before you disconnect from the system, ensure that you have
saved the configuration using the configuration save command.
For a procedure see “Logging out of the System” on page 3-18.
To Next Page
Loading...
