Ciena 5150 - Installing the 19 Frame Mount Bracket - 2 RU

Mounting Options 8-7
5150 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3222-001 Standard Revision H
Copyright
©
2012-2015 Ciena
®
Corporation July 2015
Procedure 8-2
Installing the 19” Frame Mount Bracket - 2 RU
Step Action
1 Align the holes of the mounting bracket with the holes on the side of the unit
(see Figure 8-4) as follows:
• install screws in holes 1, 3, 4, and 6
Figure 8-4
Mounting bracket with holes labeled
2 Repeat step 1 to install the second bracket.
3 Position the chassis in place in the frame.
4 Install four customer supplied screws in the slots on both the left and right
brackets.
5 Tighten all screws to ensure they make a firm connection between the
bracket and the frame.
6 Install the cable supports on the mounting brackets using the available screw
position and the two longer 8-32 screws provided in the kit. Two screws are
used per bracket. Figure 8-1 on page 8-3 shows the Cable Supports installed
on the mounting bracket.
7 Use the cable support brackets to dress and secure the cables. Use local
practices to secure the cables. Ensure that the weight of the cable is
supported and does not drag on the plug. For detailed cabling information,
see the hardware installation manual for the unit.
You have successfully mounted the unit.