5-1
5160 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3207-001 Standard Revision A
Copyright
©
2013 Ciena
®
Corporation September 2013
LED Overview 5-
This chapter provides an overview of the LED indications available in the
system. It contains the following sections:
• “Unit Status LEDs”
• “Power Supply LEDs”
• “1/10 Gigabit Ethernet Port LEDs”
• “Local Management Port LEDs”
• “Sync Port”
All interfaces on the 5160 are accessible from the faceplate of the unit. Most
interfaces have integrated LEDs which provide status information for the port.
However, a few ports do not have LEDs.
The ports that do not have LEDs are:
• 1PPS
•10MHz
•Alarm
• Console
Note: The connector for the Console port has LEDs, however these LEDs
are not used. They will not light at any time.
Figure 1-1 on page 1-1 shows the faceplate of the unit and identifies the
locations of the different ports.
To Next Page
Loading...
