8-1
5160 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3207-001 Standard Revision A
Copyright
©
2013 Ciena
®
Corporation September 2013
Mounting Options 8-
Ciena has qualified some mounting brackets that can be used to mount the
1 rack unit products in the portfolio. This chapter contains the detailed
mounting instructions for 1 RU products only. The instructions will also specify
which products each bracket has been approved for.
This chapter contains the following:
• “Wallmount Bracket Installation Instructions”
• “19” Frame Mount Bracket - 1 RU”
• “23” Frame Mount Bracket - 1 RU”
Wallmount Bracket Installation Instructions
Orderable Part Number: 170-0023-900 (Mounting Bracket Kit)
Can be used to mount the following products:
•3920
•3930
•3932
•3940
•3960
•5140
•5142
•5150
•5160
The wallmount bracket is attached to the sides of an unpowered/unconnected
chassis and used to hang the unit onto the wall. Units may be oriented for
either left or right access. Figure 8-1 on page 8-2 shows a 3920 installed using
the wallmount brackets.
To Next Page
Loading...
