Jan 24, 2008 iii
WARNING 1
Read and understand this entire Manual and your employer’s safety practices before installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the Manufacturer assumes no liability for its use.
Welding Power Supply
Instruction Manual Number 719557 for:
TRANSMIG 225 Power Source (Compact) Spec Number 710001
TRANSMIG 255 Power Source (Compact) Spec Number 710007
TRANSMIG 255 Power Source (Remote) Spec Number 710002
TRANSMIG 255 2R Wire Feeder (Remote) Spec Number 707593
Published by:
CIGWELD Pty Ltd
71 Gower Street
Preston, Victoria, Australia, 3072
www.cigweld.com.au
Copyright 2008 by
CIGWELD
All rights reserved.
A reproduction of this work, in whole or in part, without written permission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused by any error or omission in
this Manual, whether such error results from negligence, accident, or any other cause.
Publication Date: September 4
th
, 2008
Record the following information for Warranty purposes:
Where Purchased: ___________________________________________
Purchase Date: ___________________________________________
Equipment Serial #: ___________________________________________
To Next Page
Loading...
