43
5.8 Temporary Factory Reset
Do not reset the server unless the administrator forgets admin password or cannot log in the server.
Please note: all the settings you did and your data before you do the reset will come back when you
power off and restart the server.
Steps:
●Use a toothpick or stick like this to press the RST button and hold for about 10 secs and release when
there’s a long beep. The server at this time will be in maintenance mode.
●Wait for a moment. The READY light at the front panel of the server box will be out or flashing.
●When READY light becomes steady, the server is successfully back in factory settings.
●Server network settings will be restored to factory set. IP address: 192.168.1.2 and subnet mask:
255.255.0.0.
●Admin password will be restored to: “admin”.
●Login the server with factory IP address (192.168.1.2), user name (admin) and password (admin).
Click “Server” and then “User Account” to change admin account and password. Click “Apply”. Or
“Network Settings” to change the server’s IP address.
●Power off the server and then power on to restart it. Please note: if you didn’t change IP address
during the reset, the IP address will be auto set back to the one before your reset. Login the server with
the IP you set and the new admin account and password.
To Next Page
Loading...
