Cisco 3.3 User Manual

F-15
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
Appendix F RDBMS Synchronization Import Definitions
Action Codes
Transactions using these codes affect the configuration displayed in the User
Setup and Group Setup sections of the HTML interface. For more information
about the User Setup section, see Chapter 7, “User Management”. For more
information about the Group Setup section, see Chapter 6, “User Group
Management”.
Table F-4 Action Codes for Initializing and Modifying Access Filters
Action
Code Name Required Description
120 INIT_NAS_ACCESS_
CONTROL
UN|GN,V1 Clears the AAA client access filter list and
initialize permit/deny for any forthcoming
filters. V1 should be one of the following values:
• ACCESS_PERMIT
• ACCESS DENY
121 INIT_DIAL_ACCESS_
CONTROL
UN|GN,V1 Clears the dial-up access filter list and initialize
permit/deny for any forthcoming filters. V1
should be one of the following values:
• ACCESS_PERMIT
• ACCESS DENY
122 ADD_NAS_ACCESS_
FILTER
UN|GN,V1 Adds a AAA client filter for the user|group.
V1 should contain a single (AAA client name,
AAA client port, remote address, CLID) tuple;
for example:
NAS01,tty0,0898-69696969
Optionally, the AAA client name can be “All
AAA clients” to specify that the filter applies to
all configured AAA clients and an asterisk (*) to
represent all ports.

Cisco 3.3 Specifications

General

Brand	Cisco
Model	3.3
Category	Software
Language	English