Cisco 3032 - Enabling HSRP Version 2

39-26
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 39 Configuring IPv6 Unicast Routing
Configuring IPv6
Enabling HSRP Version 2
Beginning in privileged EXEC mode, follow these steps to enable HSRP version 2 on a Layer 3 interface.
Enabling an HSRP Group for IPv6
Beginning in privileged EXEC mode, follow these steps to create or enable HSRP for IPv6 on a Layer 3
interface.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and enter the
Layer 3 interface on which you want to specify the
standby version.
Step 3
standby version {1 | 2}Enter 2 to change the HSRP version. The default is 1.
Step 4
end Return to privileged EXEC mode.
Step 5
show standby Verify the configuration.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and enter the Layer 3
interface on which you want to enable HSRP for IPv6.
Step 3
standby [group-number] ipv6 {link-local-address
| autoconfig}
Create (or enable) the HSRP for IPv6 group.
• (Optional) group-number—The group number on the
interface for which HSRP is being enabled. The range is 0
to 4095. The default is 0. If there is only one HSRP group,
you do not need to enter a group number.
• Enter the link-local address of the Hot Standby router
interface, or enable the link-local address to be generated
automatically from the link-local prefix and a modified
EUI-64 format interface identifier, where the EUI-64
interface identifier is created from the relevant HSRP
virtual MAC address.