Cisco 3032 - Software Loopback Example: no Connected Stack Cable

5-31
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 5 Managing Switch Stacks
Troubleshooting Stacks
Switch 1 is a standalone switch.
Switch# show switch stack-ports summary
Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
1/1 Absent None No cable No No No 1 Yes
1/2 Absent None No cable No No No 1 Yes
Software Loopback Example: No Connected Stack Cable
Port status:
Switch# show switch stack-ports summary
Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
1/1 Absent None No cable No No No 1 Yes
1/2 Absent None No cable No No No 1 Yes
Software Loopback Examples: Connected Stack Cables
• On Port 1 on Switch 1, the port status is Down, and a cable is connected.
On Port 2 on Switch 1, the port status is Absent, and no cable is connected.
Switch# show switch stack-ports summary
Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
1/1 Down None 50 Cm No No No 1 No
1/2 Absent None No cable No No No 1 No
• In a physical loopback, a cable connects both stack ports on a switch. You can use this configuration
to test
– Cables on a switch that is running properly
– Stack ports with a cable that works properly
Switch# show switch stack-ports summary
Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
2/1 OK 2 50 cm Yes Yes Yes 1 No
2/2 OK 2 50 cm Yes Yes Yes 1 No
The port status shows that
– Switch 2 is a standalone switch.
– The ports can send and receive traffic.