1-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 1 Overview
Features
Security Features
The switch ships with these security features:
• Web authentication to allow a supplicant (client) that does not support IEEE 802.1x functionality to
be authenticated using a web browser.
• Password-protected access (read-only and read-write access) to management interfaces (device
manager, Network Assistant, and the CLI) for protection against unauthorized configuration
changes
• Multilevel security for a choice of security level, notification, and resulting actions
• Static MAC addressing for ensuring security
• Protected port option for restricting the forwarding of traffic to designated ports on the same switch
• Port security option for limiting and identifying MAC addresses of the stations allowed to access
the port
• VLAN aware port security option to shut down the VLAN on the port when a violation occurs,
instead of shutting down the entire port
• Port security aging to set the aging time for secure addresses on a port
• BPDU guard for shutting down a Port Fast-configured port when an invalid configuration occurs
• Standard and extended IP access control lists (ACLs) for defining security policies in both directions
on routed interfaces (router ACLs) and VLANs and inbound on Layer 2 interfaces (port ACLs)
• Extended MAC access control lists for defining security policies in the inbound direction on Layer 2
interfaces
• VLAN ACLs (VLAN maps) for providing intra-VLAN security by filtering traffic based on
information in the MAC, IP, and TCP/UDP headers
• Source and destination MAC-based ACLs for filtering non-IP traffic
• IPv6 ACLs to be applied to interfaces to filter IPv6 traffic
• DHCP snooping to filter untrusted DHCP messages between untrusted hosts and DHCP servers
• IP source guard to restrict traffic on nonrouted interfaces by filtering traffic based on the DHCP
snooping database and IP source bindings
• Dynamic ARP inspection to prevent malicious attacks on the switch by not relaying invalid ARP
requests and responses to other ports in the same VLAN
• IEEE 802.1Q tunneling so that customers with users at remote sites across a service-provider
network can keep VLANs segregated from other customers and Layer 2 protocol tunneling to ensure
that the customer’s network has complete STP, CDP, and VTP information about all users
• Layer 2 point-to-point tunneling to facilitate the automatic creation of EtherChannels
• Layer 2 protocol tunneling bypass feature to provide interoperability with third-party vendors
To Next Page
