Cisco 3032 - Assigning Stack Member Information

5-24
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 5 Managing Switch Stacks
Configuring the Switch Stack
This example shows how to configure the persistent MAC address feature for a 7-minute time delay and
to verify the configuration:
Switch(config)# stack-mac persistent timer 7
WARNING: The stack continues to use the base MAC of the old Master
WARNING: as the stack MAC after a master switchover until the MAC
WARNING: persistency timer expires. During this time the Network
WARNING: Administrators must make sure that the old stack-mac does
WARNING: not appear elsewhere in this network domain. If it does,
WARNING: user traffic may be blackholed.
Switch(config)# end
Switch# show switch
Switch/Stack Mac Address : 0016.4727.a900
Mac persistency wait time: 7 mins
H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master 0016.4727.a900 1 0 Ready
Assigning Stack Member Information
These sections describe how to assign stack member information:
• Assigning a Stack Member Number, page 5-24 (optional)
• Setting the Stack Member Priority Value, page 5-25 (optional)
• Provisioning a New Member for a Switch Stack, page 5-25 (optional)
Assigning a Stack Member Number
Note This task is available only from the stack master.
Beginning in privileged EXEC mode, follow these steps to assign a member number to a stack member.
This procedure is optional.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
switch current-stack-member-number
renumber new-stack-member-number
Specify the current stack member number and the new stack member
number for the stack member. The range is 1 to 9.
You can display the current stack member number by using the show
switch user EXEC command.
Step 3
end Return to privileged EXEC mode.
Step 4
reload slot stack-member-number Reset the stack member.
Step 5
show switch Verify the stack member number.
Step 6
copy running-config startup-config Save your entries in the configuration file.