7-21
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 7 Configuring Switch-Based Authentication
Controlling Switch Access with RADIUS
This section includes these topics:
• CoA Request Response Code
• CoA Request Commands
• Session Reauthentication
RFC 5176 Compliance
The Disconnect Request message, which is also referred to as Packet of Disconnect (POD), is supported
by the switch for session termination.
Table 7-2 shows the IETF attributes are supported for this feature.
Table 7-3 shows the possible values for the Error-Cause attribute.
Table 7-2 Supported IETF Attributes
Attribute Number Attribute Name
24 State
31 Calling-Station-ID
44 Acct-Session-ID
80 Message-Authenticator
101 Error-Cause
Table 7-3 Error-Cause Values
Value Explanation
201 Residual Session Context Removed
202 Invalid EAP Packet (Ignored)
401 Unsupported Attribute
402 Missing Attribute
403 NAS Identification Mismatch
404 Invalid Request
405 Unsupported Service
406 Unsupported Extension
407 Invalid Attribute Value
501 Administratively Prohibited
502 Request Not Routable (Proxy)
503 Session Context Not Found
504 Session Context Not Removable
505 Other Proxy Processing Error
506 Resources Unavailable
507 Request Initiated
508 Multiple Session Selection Unsupported
To Next Page