5-23
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 5 Managing Switch Stacks
Configuring the Switch Stack
Beginning in privileged EXEC mode, follow these steps to enable persistent MAC address. This
procedure is optional.
Use the no stack-mac persistent timer global configuration command to disable the persistent MAC
address feature.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
stack-mac persistent timer [0 |
time-value]
Enable a time delay after a stack-master change before the stack MAC
address changes to that of the new stack master. If the previous stack
master rejoins the stack during this period, the stack uses that MAC
address as the stack MAC address.
• Enter the command with no value to set the default delay of
approximately 4 minutes. We recommend that you always configure
a value.
• Enter 0 to continue using the MAC address of the current stack
master indefinitely.
• Enter a time-value from 1 to 60 minutes to configure the time period
before the stack MAC address changes to the new stack master.
Note When you enter this command, a warning states that traffic
might be lost if the old master MAC address appears elsewhere
in the network domain.
If you enter the no stack-mac persistent timer command after a new
stack master takes over, before the time expires, the switch stack moves
to the current stack master MAC address.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config
or
Verify that the stack MAC address timer is enabled. If enabled, the
output shows
stack-mac persistent timer and the time in minutes.
Step 5
show switch If enabled, the display includes:
Mac persistency wait time, the number of minutes configured, and
the current stack MAC address.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
