Cisco 3032 - Page 1318

Index
IN-20
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
inaccessible authentication bypass 9-22
support for multiauth ports 9-22
initial configuration
defaults
1-17
Express Setup 1-2
interface
number
11-8
range macros 11-11
interface command 11-8 to 11-9
interface configuration mode 2-2
interfaces
auto-MDIX, configuring
11-22
configuring
procedure
11-9
counters, clearing 11-29
default configuration 11-17
described 11-23
descriptive name, adding 11-23
displaying information about 11-28
duplex and speed configuration guidelines 11-19
flow control 11-21
management 1-5
monitoring 11-28
naming 11-23
physical, identifying 11-8
range of 11-10
restarting 11-29
shutting down 11-29
speed and duplex, configuring 11-20
status 11-28
supported 11-8
types of 11-1
interfaces range macro command 11-11
interface types 11-8
Interior Gateway Protocol
See IGP
internal BGP
See IBGP
internal neighbors, BGP
38-50
Internet Control Message Protocol
See ICMP
Internet Group Management Protocol
See IGMP
Internet Protocol version 6
See IPv6
Inter-Switch Link
See ISL
inter-VLAN routing
1-14, 38-2
Intrusion Detection System
See IDS appliances
inventory management TLV
29-2, 29-7
IP ACLs
for QoS classification
36-8
implicit deny 34-10, 34-14
implicit masks 34-10
named 34-15
undefined 34-21
IP addresses
128-bit
39-2
classes of 38-7
default configuration 38-6
discovering 6-30
for IP routing 38-5
IPv6 39-2
MAC address association 38-9
monitoring 38-18
IP base feature set 1-1
IP broadcast address 38-16
ip cef distributed command 38-93
IP directed broadcasts 38-15
ip igmp profile command 24-25
IP information
assigned
manually
3-15
through DHCP-based autoconfiguration 3-3
default configuration 3-3