Cisco 3032 - Page 1338

Index
IN-40
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
remote SPAN 30-3
report suppression, IGMP
described
24-6
disabling 24-16, 25-11
resequencing ACL entries 34-15
reserved addresses in DHCP pools 22-27
resets, in BGP 38-53
resetting a UDLD-shutdown interface 28-6
responder, IP SLAs
described
41-3
enabling 41-7
response time, measuring with IP SLAs 41-4
restricted VLAN
configuring
9-50
described 9-21
using with IEEE 802.1x 9-21
restricting access
NTP services
6-8
overview 7-1
passwords and privilege levels 7-2
RADIUS 7-17
TACACS+ 7-10
retry count, VMPS, changing 13-31
reverse address resolution 38-9
Reverse Address Resolution Protocol
See RARP
RFC
1112, IP multicast and IGMP
24-2
1157, SNMPv1 33-2
1166, IP addresses 38-7
1305, NTP 6-2
1587, NSSAs 38-27
1757, RMON 31-2
1901, SNMPv2C 33-2
1902 to 1907, SNMPv2 33-2
2236, IP multicast and IGMP 24-2
2273-2275, SNMPv3 33-2
RFC 5176 Compliance 7-21
RIP
advertisements
38-20
authentication 38-24
configuring 38-21
default configuration 38-21
described 38-20
for IPv6 39-7
hop counts 38-20
split horizon 38-25
summary addresses 38-25
support for 1-14
RMON
default configuration
31-3
displaying status 31-6
enabling alarms and events 31-3
groups supported 31-2
overview 31-1
statistics
collecting group Ethernet
31-5
collecting group history 31-5
support for 1-16
root guard
described
20-10
enabling 20-18
support for 1-8
root switch
MSTP
19-17
STP 18-16
route calculation timers, OSPF 38-34
route dampening, BGP 38-65
routed packets, ACLs on 34-39
routed ports
configuring
38-5
defined 11-4
IP addresses on 11-24, 38-5
route-map command 38-103
route maps
BGP
38-56
policy-based routing 38-100