Cisco 3032 - Page 1347

Index
IN-49
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Switch Database Management
See SDM
switched packets, ACLs on
34-37
Switched Port Analyzer
See SPAN
switched ports
11-2
switchport backup interface 21-4, 21-5
switchport block multicast command 26-8
switchport block unicast command 26-8
switchport command 11-17
switchport mode dot1q-tunnel command 17-6
switchport protected command 26-7
switch priority
MSTP
19-21
STP 18-21
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP
38-50
syslog
See system message logging
system capabilities TLV
29-2
system clock
configuring
daylight saving time
6-13
manually 6-11
summer time 6-13
time zones 6-12
displaying the time and date 6-12
overview 6-1
See also NTP
system description TLV
29-2
system message logging
default configuration
32-4
defining error message severity levels 32-9
disabling 32-4
displaying the configuration 32-14
enabling 32-5
facility keywords, described 32-14
level keywords, described 32-10
limiting messages 32-10
message format 32-2
overview 32-1
sequence numbers, enabling and disabling 32-8
setting the display destination device 32-5
stack changes, effects of 32-2
synchronizing log messages 32-6
syslog facility 1-16
time stamps, enabling and disabling 32-8
UNIX syslog servers
configuring the daemon
32-13
configuring the logging facility 32-13
facilities supported 32-14
system MTU
and IS-IS LSPs
38-72
system MTU and IEEE 802.1Q tunneling 17-5
system name
default configuration
6-15
default setting 6-15
manual configuration 6-15
See also DNS
system name TLV
29-2
system prompt, default setting 6-14, 6-15
system resources, optimizing 8-1
system routing
IS-IS
38-67
ISO IGRP 38-67
T
TACACS+
accounting, defined
7-11
authentication, defined 7-11
authorization, defined 7-11